Peristaltic pump for muds.


 Click on link to right.

description

i links

Ragione sociale:

ACME pumps

 

 

peristaltic pumps - hose pumps

 

 

Working principle

The casing contains a special high elasticity and resistance hose, which is flanged at both ends (connections). The flanges are connected to the suction and discharge lines of the system. Within the casing is a rotor with two rollers at opposite points about its centre line and mounted on a shaft with bearings. As a result of the rotor pivoting, the hose is totally compressed by the rollers and the product within the hose is pushed forward. The sucking action comes as restores its original cylindrical form after compression. The worn surface must be lubricated with siliconic grease.

Are available even with fiber reinforced constructions, in a lot of compounds to choose according to service conditions.

Easy to clean and sterilize.

The pumped fluid doesn't contact any mechanical part.

Simply adjustable.

Few wearing part.

Easy maintenance, low cost, short down time.

Lubrication with siliconic grease.

Italian industrial factory producing peristaltic pumps: dosing, for abrasives, for corrosive, alimentary and paste industries

 

 

You'll find here:

 

Italian factory producing : peristaltic pump for muds abrasives, corrosives, alimentary. Muds, abrasive and alimentary.

 

Expecially tested on mud, abrasive, alimentary and corrosive products.


 
 


 

  index